WHAT YOU NEED FOR THIS JOB ?
- TOOLS: Cutting Plier, Knife, Screw Driver
- MATERIALS : Insulation Wire, 2/3 Pin Plug
Let's Start the process :
Step-1: Take a plug and unscrew the screw nuts.
Step-2: Remove the back cap of the plug and place it a side.
Step-3: Take the insulation wire and remove the insulation for 0.5-1Cm.
Step-4: Now place the wire into phase and neutral terminals in the plug. ( Earthing is optional, depends upon 2/3 terminal plug). And tight the screw, Using a screw driver or electric tester.
Step-5: Replace the support plate and back cap for the plug.
Omg ! That's it ...I'm done with my task!
No comments:
Post a Comment